Cisco Catalyst 2960-L Series - SFP Module Slots; Leds

SFP Module Slots
The switch has two 1G SFP module slots. The SFP modules provide copper or fiber-optic connections to
other devices. These transceiver modules are field replaceable, and provide the uplink interfaces when installed
in an SFP module slot. The SFP modules have LC connectors for fiber-optic connections or RJ-45 connectors
for copper connections. The SFP slots support only SFP modules.
For Cisco SFP modules documentation, including compatibility matrixes, refer to this URL:
http://www.cisco.com/en/US/products/hw/modules/ps5455/products_device_support_tables_list.html
Table 2: Port mapping for Cisco Catalyst 2960-L 24-Port Switch models
10-GigabitEthernet ports1-GigabitEthernet ports
TenGigabitEthernet0/1GigabitEthernet0/25
TenGigabitEthernet0/2GigabitEthernet0/26
TenGigabitEthernet0/3GigabitEthernet0/27
TenGigabitEthernet0/4GigabitEthernet0/28
Table 3: Port mapping for Cisco Catalyst 2960-L 48-Port Switch models
10-GigabitEthernet ports1-GigabitEthernet ports
TenGigabitEthernet0/1GigabitEthernet0/49
TenGigabitEthernet0/2GigabitEthernet0/50
TenGigabitEthernet0/3GigabitEthernet0/51
TenGigabitEthernet0/4GigabitEthernet0/52
If you insert a 10G SFP+ in to a 1G SFP module slot and vice versa, you need to clear the existing configuration
by running the default-interface <interface-number> command on the mapped ports. For more information
about the command, refer to the Software Configuration Guide.
Note
LEDs
You can use the switch system and port LEDs to monitor switch activity and performance.
Cisco Catalyst 2960-L Series 8-Port and 16-Port Switch Hardware Installation Guide
5
Product Overview
SFP Module Slots