Cisco Catalyst 2960-L Series User Manual

Step 2 Pull down on the DIN rail mount release tabs. As the clips release, lift the bottom of the switch.
Figure 26: Switch Removal
Installing the Power Cord Retainer (Optional)
This section applies to switches with an AC power connector.
Note
The power cord retainer (PWR-CLP=) is optional. You can order it when you order your switch, or you can
order it later from your Cisco representative.
Step 1 Choose the sleeve size of the power cord retainer based on the thickness of the cord. The smaller sleeve can be snapped
off and used for thin cords.
Step 2 Slide the retainer around the AC power cord, and pass it around the loop on the switch.
Cisco Catalyst 2960-L Series 8-Port and 16-Port Switch Hardware Installation Guide
32
Switch Installation
Installing the Power Cord Retainer (Optional)

Cisco Catalyst 2960-L Series Specifications

General

Series	Catalyst 2960-L
Ports	8, 16, 24, or 48 Gigabit Ethernet ports
Layer	Layer 2
Flash Memory	64 MB
MAC Address Table Size	8, 000 entries
Uplink	2 or 4 Gigabit SFP
PoE	Available on selected models
VLAN Support	Up to 255 VLANs
Power Supply	Internal power supply
Operating Temperature	0°C to 40°C (32°F to 104°F)
Dimensions	44.5 x 27.9 x 4.45 cm (17.5 x 11.0 x 1.75 in.)