Cisco Catalyst 2960-L Series User Manual

APPENDIX C
Configuring the Switch
This appendix contains these topics:
• Configuring the Switch Using the Configuration Setup Wizard, on page 59
• Configuring the Switch Using the CLI, on page 61
Configuring the Switch Using the Configuration Setup Wizard
Quick Setup: Accessing the Configuration Setup Wizard
When you first set up the switch, use the Configuration Setup wizard to enter the initial IP information. This
enables the switch to connect to local routers and the Internet. You can then access the switch through the IP
address for further configuration.
If your device supports Bluetooth, it loads with the initial setup tasks preconfigured. Connect your PC to the
device using Bluetooth. In your Web browser, enter the IP address 172.16.0.1. Enter the following default
credentials: username: cisco, password: cisco and press Enter.
Note
Cisco Catalyst 2960-L Series 8-Port and 16-Port Switch Hardware Installation Guide
59

Cisco Catalyst 2960-L Series Specifications

General

Series	Catalyst 2960-L
Ports	8, 16, 24, or 48 Gigabit Ethernet ports
Layer	Layer 2
Flash Memory	64 MB
MAC Address Table Size	8, 000 entries
Uplink	2 or 4 Gigabit SFP
PoE	Available on selected models
VLAN Support	Up to 255 VLANs
Power Supply	Internal power supply
Operating Temperature	0°C to 40°C (32°F to 104°F)
Dimensions	44.5 x 27.9 x 4.45 cm (17.5 x 11.0 x 1.75 in.)