© 2004 Boson Software, Inc. All Rights Reserved. 52
Configuring your own labs for use with the “Grade Lab” feature.
This powerful feature allows you to customize the Cisco CCNA Network Simulator to grade any custom
lab that you make on your own. In order to have a lab that the Grade My Lab feature can accommodate,
you must perform the following steps:
1. Open the Cisco CCNA Network Designer
2. Design the network topology that your lab will use.
3. Name and Save the topology that you have created.
4. Open the Cisco CCNA Network Simulator and add all of the devices configurations.
Note: This step is of particular importance. Make sure that all devices and connections are
properly configured. Whenever the “Grade My Lab” feature runs on your lab it will check the lab
in question against your configurations. Any configuration errors in your lab will result in
inaccurate results on the part of the “Grade My Lab” feature
5. Name and Save your configurations.
6. Open the “Completed Labs” folder.
7. Copy your NWC and RTR files into the “Completed Labs” folder.
8. Open the file “GradeMeLabs.txt”
Note: Once you have opened “GradeMeLabs.txt” on the line after the last line of the text file, add
the name of the lab as you would like displayed then a ”,” followed by the name of your .NWC
file. *Example: My Own Lab - #2, lab 2
9. Save the “GradeMeLabs.txt” file (do not rename it.)
The next time you open the “Grade My Labs” feature, you will see the customized lab that you added.
To Next Page
Loading...
Need help?
General