© 2004 Boson Software, Inc. All Rights Reserved. 61
Network Designer - Making Interface Connections Between Devices with Drag-n-Drop
Manually Making Connections.
Note: An Add Connector Wizard is also available.
The Network Designer supports five different types of interface connections:
Serial, Ethernet, Fast Ethernet, ISDN/PRI, and Frame Relay.
To select an Interface Connection Type
1. Left - Click the plus sign next to "Available Connections"
2. After “Available Connections” has been selected, the option expands to show all available
Connections.
3. Left - Click on the plus sign next to the selected Connection Type.
4. Drag-n-Drop the selected Connection Type to the NetMap Topology physical layout window.
* A note on Fast Ethernet connections. Fast Ethernet does not have its own connection item in
the tree view. If a device has Fast Ethernet connections available they can be accessed by
selecting Ethernet.
* A note on Frame Relay Connections. Because Frame Relays are Point to Multi-Point Serial
connections, they must be selected from within the Serial connection type.
To Next Page
Loading...
Need help?
General