© 2004 Boson Software, Inc. All Rights Reserved. 67
Network Designer - Connecting Multipoint Serial between Devices
Manually Connecting Frame Relay Interfaces
Note: If you use the Add Connector Wizard, select the Serial Interface, then Multi-Point option, to be
guided through the process.
Select the Point to Multi-Point Serial Connection for Frame Relay
1. Select Serial from the "Available Connections" list
2. The Network Designer will ask what type of serial connection you would like to make.
3. Select Point to Multi-Point Serial Connection (Frame Relay)
…continued…
To Next Page
Loading...
Need help?
General