Cisco CISCO851-K9 - 851 Integrated Services Router - Page 136

13-18
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
OL-5332-01
Chapter 13 Configuring Dial Backup and Remote Management
Configuring Dial Backup and Remote Management Through the ISDN S/T Port
Perform these steps to configure your router ISDN interface for use as a backup interface, beginning in
global configuration mode:
Command Purpose
Step 1
isdn switch-type switch-type
Example:
Router(config)# isdn switch-type basic-net3
Router(config)#
Specifies the ISDN switch type.
The example specifies a switch type used in
Australia, Europe, and the United Kingdom. For
details on other switch types supported, see the
Cisco IOS Dial Technologies Command
Reference.
Step 2
interface type number
Example:
Router(config)# interface bri 0
Router(config-if)#
Enters configuration mode for the ISDN Basic
Rate Interface (BRI).
Step 3
encapsulation encapsulation-type
Example:
Router(config-if)# encapsulation ppp
Router(config-if)#
Sets the BRI0 interface encapsulation type.
Step 4
dialer pool-member number
Example:
Router(config-if)# dialer pool-member 1
Router(config-if)#
Specifies the dialer pool membership.
Step 5
isdn switch-type switch-type
Example:
Router(config-if)# isdn switch-type
basic-net3
Router(config-if)#
Specifies the ISDN switch type.
Step 6
exit
Example:
Router(config-if)# exit
Router(config)#
Enters global configuration mode.
Step 7
interface dialer dialer-rotary-group-number
Example:
Router(config)# interface dialer 0
Router(config-if)#
Creates a dialer interface (numbered 0–255) and
enters interface configuration mode.