Cisco CISCO851-K9 - 851 Integrated Services Router - Page 137

13-19
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
OL-5332-01
Chapter 13 Configuring Dial Backup and Remote Management
Configuring Dial Backup and Remote Management Through the ISDN S/T Port
Step 8
ip address negotiated
Example:
Router(config-if)# ip address negotiated
Router(config-if)#
Specifies that the IP address for the interface is
obtained through PPP/IPCP (IP Control Protocol)
address negotiation. The IP address is obtained
from the peer.
Step 9
encapsulation encapsulation-type
Example:
Router(config-if)# encapsulation ppp
Router(config-if)#
Sets the encapsulation type to PPP for the
interface.
Step 10
dialer pool number
Example:
Router(config-if)# dialer pool 1
Router(config-if)#
Specifies the dialer pool to be used.
In the example, the dialer pool 1 setting associates
the dialer 0 interface with the BRI0 interface
because the BRI0 dialer pool-member value is 1.
Step 11
dialer string dial-string[:isdn-subaddress]
Example:
Router(config-if)# dialer string 384040
Router(config-if)#
Specifies the telephone number to be dialed.
Step 12
dialer-group group-number
Example:
Router(config-if)# dialer group 1
Router(config-if)#
Assigns the dialer interface to a dialer group
(1–10).
Step 13
exit
Example:
Router(config-if)# exit
Router(config)#
Exits dialer 0 interface configuration mode, and
enters global configuration mode.
Step 14
dialer-list dialer-group protocol protocol-name
{permit | deny | list access-list-number |
access-group}
Example:
Router(config)# dialer-list 1 protocol ip
permit
Router(config)#
Creates a dialer list for packets of interest to be
forwarded through the specified interface dialer
group.
In the example, dialer-list 1 corresponds to
dialer-group 1.
For details about this command and additional
parameters that can be set, see the
Cisco IOS Dial
Technologies Command Reference.
Command Purpose