Introduction
Connecting to Your Wireless Network
Cisco CVR100W Wireless-N VPN Router Administration Guide 21
1
• Connect a computer to an available LAN port and verify that you can
connect to a website on the Internet, such as www.cisco.com.
• Configure a device to connect to your wireless network and verify the
wireless network is functional. See Connecting to Your Wireless Network.
Connecting to Your Wireless Network
To connect a device (such as a computer) to your wireless network, configure the
wireless connection on the device with the wireless security information you
configured for the CVR100W using the Setup Wizard.
NOTE If you want to connect a device to your wireless network to do the initial
configuration for the first time, use the default SSID name and pre-shared key are
provided on the product label at the bottom of the CVR100W.
The following steps are provided as an example; you may need to configure your
device differently. For instructions that are specific to your device, consult its
documentation.
STEP 1 Open the wireless connection settings window or program for your device.
Your computer may have special software installed to manage wireless
connections, or you may find wireless connections under the Control Panel in the
Network Connections or Network and Internet window. (The location depends
on your operating system.)
STEP 2 Enter the network name (SSID) you chose for your network in the Setup Wizard.
STEP 3 Choose the type of encryption and enter the security key that you specified in the
Setup Wizard.
If you did not enable security (not recommended), leave the wireless encryption
fields that were configured with the security type and passphrase blank.
STEP 4 Verify your wireless connection and save your settings.
To Next Page
Loading...
Need help?
General
