Cisco CVR100W Administration Guide

Configuring Network
Configuring IPv6
Cisco CVR100W Wireless-N VPN Router Administration Guide 56
3
STEP 4 Click Save.
Configuring IPv6 LAN Settings
In the IPv6 mode, the LAN DHCP server is enabled by default (similar to the IPv4
mode). The DHCPv6 server assigns IPv6 addresses from configured address
pools that use the IPv6 prefix length assigned to the LAN.
Setting the IP Mode
To configure IPv6 LAN settings on your CVR100W, you must first set the IP mode
to one of the following modes:
• LAN:IPv6, WAN:IPv4
• LAN:IPv6, WAN:IPv6
• LAN:IPv4+IPv6, WAN:IPv4
• LAN:IPv4+IPv6, WAN:IPv4+IPv6
See Configuring IP Mode for more information.
Configuring IPv6 LAN Settings
To configure IPv6 LAN settings:
STEP 1 Choose Networking > IPv6 Configuration > IPv6 LAN Configuration.
STEP 2 In the IPv6 area, enter the following information to configure the IPv6 LAN address:
Static DNS 1 Enter the IP address of the primary DNS server on the
ISP’s IPv6 network.
Static DNS 2 Enter the IP address of the secondary DNS server on
the ISP’s IPv6 network.
IPv6 Address Enter the IPv6 address of the CVR100W.
The default IPv6 address for the gateway is fec0::1.
You can change this 128-bit IPv6 address based on
your network requirements.

Cisco CVR100W Specifications

General

Brand	Cisco
Model	CVR100W
Category	Network Router
Language	English