Configuring Wireless Network
Configuring WPS
Cisco CVR100W Wireless-N VPN Router Administration Guide 84
4
• If the client device has a WPS PIN number, enter the PIN number and click
Register. After configuration is completed, click OK.
Refer to your client device or its documentation for further instructions.
• If the client device requires a PIN number from the router, use the number
listed in item 3 on the WPS page.
After you configure WPS, the following information appears at the bottom of the
WPS page: Wi-Fi Protected Setup Status, Network Name (SSID), and Security.
The status of the WPS light on the front panel provides information about the WPS
operation.
WPS Successfully
Started
WPS light turns on for 120 seconds.
WPS During Startup WPS light flashes (0.5 Hz) for 30 seconds.
WPS Errors
Occurred
WPS light flashes (1 Hz) for 30 seconds.
WPS Session
Overlap
WPS light flashes (0.1 Hz) in one second and turns off
next second for 120 seconds.
WPS Enabled or
Disabled
WPS light is off.
To Next Page
Loading...
Need help?
General
