Configuring Firewall
Configuring Access Control
Cisco CVR100W Wireless-N VPN Router Administration Guide 93
5
• Telnet SSL
• Voice (SIP)
(Optional) Click Configure Services to go to the Service Management page to
configure the services before applying access rules to them.
STEP 7 In the Source IP field, select the users to which the access rule applies:
• Any: The rule applies to traffic originating on any host in the local network.
• Single Address: The rule applies to traffic originating on a single IP address
in the local network. Enter the address in the Start IP field.
• Address Range: The rule applies to traffic originating from an IP address
located in a range of addresses. Enter the starting IP address in the Start IP
field, and the ending IP address in the Finish field.
STEP 8 In the Destination IP field, select the users to which the access rule applies:
• Any: The rule applies to traffic originating on any host in the local network.
• Single Address: The rule applies to traffic originating on a single IP address
in the local network. Enter the address in the Start IP field.
• Address Range: The rule applies to traffic originating from an IP address
located in a range of addresses. Enter the starting IP address in the Start IP
field, and the ending IP address in the Finish field.
STEP 9 In the Log field, specify whether the packets for this rule should be logged.
To log details for all packets that match this rule, choose Always from the drop-
down menu. For example, if an outbound rule for a schedule is selected as Always
block, for every packet that tries to make an outbound connection for that service,
a message with the packet's source address and destination address (and other
information) is recorded in the log.
Enabling logging may generate a significant volume of log messages and is
recommended for debugging purposes only.
Choose Never to disable logging.
STEP 10 In the QoS Priority field, assign a priority to IP packets of this service.
The priorities are defined by QoS Level: (1 (lowest), 2, 3, 4 (highest)).
STEP 11 In the Rule Status field, check to enable the new access rule.
STEP 12 Click Save.
To Next Page
Loading...
Need help?
General
