Configuring Transport Stream Information
This is the output bit rate of the transport stream, in Mbps.
Selects the transport protocol to use for the output stream (UDP or
RTP).
Enter the unicast (valid host IP only) or multicast destination IP
address.
This selects the destination port number (1 to 65534).
Note: If you selected RTP for Encapsulation, you must choose an
even destination port number.
2 To modify the stream information, click the radio button of a stream and click
Edit.
3 Make the necessary changes and click Save.
4 To configure advanced stream settings, click a radio button of a stream and click
Advanced.
The following table describes the advanced settings:
Sets the quality of service (0 to 255).
This sets the hop limit of the packet's lifespan (0 to 255).
This sets the source UDP port number (0 to 65535).
Note: Set the Source UDP Port to 0 to use the default UDP
port (49162).
Choose RFC 2327 to send the Session Announcement
Protocol (SAP) messages according to the RFC 2327 standard.
Otherwise, choose None to not send SAP messages.
To Next Page
Loading...
