Configuring System Settings
Note: Enable/Disable must be set to Yes for the Relay and Trap settings to be
functional.
5 If current warning is enabled, choose Yes from the Trap drop-down list and the
SNMP trap message will be sent when the warning is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the warning is disabled (Enb is set to No).
6 If current warning is enabled, choose Yes from the Relay drop-down list for the
rear panel alarm relay to be triggered when the warning is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the warning is disabled (Enb is set to No).
7 Click Apply.
To Next Page
Loading...
Need help?
General
