Cisco Firepower 1010 User Manual

Step 6 On the Translation page, configure the following options:
• Original Source—Click Add ( ) to add a network object for all IPv4 traffic (0.0.0.0/0).
You cannot use the system-defined any-ipv4 object, because Auto NAT rules add NAT as part
of the object definition, and you cannot edit system-defined objects.
Note
• Translated Source—Choose Destination Interface IP.
Cisco Firepower 1010 Getting Started Guide
75
Threat Defense Deployment with a Remote Management Center
Configure NAT

Cisco Firepower 1010 Specifications

General

VPN Throughput	500 Mbps
Concurrent Sessions	100, 000
Maximum Concurrent Sessions	200, 000
Ports	8 x 1 GE
Humidity	10% to 90% non-condensing
Form Factor	Desktop
Flash Memory	8 GB
Interfaces	8 x RJ-45
Power Supply	Internal
Dimensions (H x W x D)	4.44 x 21.59 x 17.27 cm
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-20 to 70°C
Memory	4 GB