Cisco NCS 560-4

DescriptionDirectionSignal
Name
Pin
—Not
Used
DTR2
Transmit
data
OutputTXD3
—Not
Used
RI4
GND5
Receive dataInputRXD6
—Not
Used
DSR/DCD7
—Not
Used
CTS8
Management Ethernet Port Pinout
A single management copper ENET port supporting 10/100/1000Base-T operation exists on each RSP. There
is no direct access to the CPU of the other RSP. It uses a standard RJ45 jack.
This is not a data plane port.
Note
The table below summarizes the Management Ethernet port pinout.
Table 21: Management Ethernet Port Pinout
DescriptionSignal
Name
Pin
TRP0+1
TRP0-2
TRP1+3
TRP1-4
TRP2+5
TRP2-6
TRP3+7
TRP3-8
Cisco NCS 560-4 Router Hardware Installation Guide
110
Pinout and LED Details
Management Ethernet Port Pinout