Attaching the Cable Management Brackets
The router supports the following bracket:
• N560-4-CAB-BRCKT —This bracket helps in routing the cables from the interface modules, router
switch processors (RSPs), and power supply units; thereby enabling a proper cable bending radius.
You can install the cable brackets along with the rack mount screws while installing the chassis. Or, you can
install the cable brackets after the chassis is monted on the rack. However, ensure the brackets are positioned
such that they aid cable routing and provide enough slack for fan trays and air filter removal.
Note
Procedure
Step 1 Position the cable management brackets against the front of the chassis and align the four screw holes, as
shown in the figure below.
Figure 32: Attaching Cable Management Brackets to the 19-inch Rack
Cisco NCS 560-4 Router Hardware Installation Guide
62
Installing the Cisco NCS 560-4 Router
Attaching the Cable Management Brackets
To Next Page
Loading...
