Cisco NCS 560-4

Recommended Power Cables
Table 11: Power Cable PIDs for A900-PWR1200-A (1200 W)
DescriptionPID
US AC Power Cord for Cisco ASR 900, NEMA 5-20PWR-CAB-AC-USA520
Power Cord for AC V2 Power Module (USA), NEMA L6-20PPWR-CAB-AC-USA
Power Cord for AC V2 Power Module (Australia), AS 3112PWR-CAB-AC-AUS
Power Cord for AC V2 Power Module (Europe), CEE 7/7PWR-CAB-AC-EU
Power Cord for AC V2 Power Module (Italy), CEI-23-50PWR-CAB-AC-ITA
Power Cord for AC V2 Power Module (South Africa), SABS 164PWR-CAB-AC-SA
Power Cord for AC V2 Power Module (UK), EN 60309-2PWR-CAB-AC-UK
Power Cord for AC V2 Power Module (Israel), SI 32PWR-CAB-AC-ISRL
Power Cord for AC V2 Power Module (China), GB2099.1/GB1002PWR-CAB-AC-CHN
Power Cord for AC V2 Power Module (Brazil), NBR 14136PWR-CAB-AC-BRA
Power Cord for AC V2 Power Module (Swiss), SEV 1011PWR-CAB-AC-SUI
Power Cord for AC V2 Power Module (Japan), JIS C8303PWR-CAB-AC-JPN
India AC Power Cord for Cisco ASR 900, IS:1293PWR-CAB-AC-IND
AC POWER CORD, WIRE HARNESS, Argentina, IRAM 2073, IEC60320
C21, ST, 4M, 30 AWG, STRANDED, 250.0 V, 16.0 A
PWR-CAB-AC-ARG
Activating the AC Power Supply
Follow these steps to activate the AC power supply:
Procedure
Step 1 Plug the power cord into the power supply.
Step 2 Connect the other end of the power cord to an AC-input power source.
Step 3 Verify power supply operation by checking that the power supply LEDs are in the following states:
• INPUT OK LED is green
• OUTPUT FAIL LED is green
Step 4 If the LEDs indicate a power problem, see the Troubleshooting for troubleshooting information.
Step 5 If you are installing a redundant power supply, repeat these steps for the second power source.
Cisco NCS 560-4 Router Hardware Installation Guide
75
Installing the Cisco NCS 560-4 Router
Recommended Power Cables