Cisco NCS 560-4

Installation Checklist
Use the Installation Checklist that is shown in the following table to provide a record of what was done by
whom and when. Use this list to record the completion and verification of each procedure. After the checklist
is completed, place it in your Site Log along with the other records pertaining to your new Cisco router.
Table 8: Installation Checklist
DateVerified ByTask
Date on which chassis received
Chassis and all accessories unpacked
Types and numbers of interfaces verified
Safety recommendations and guidelines reviewed
Installation Checklist that is copied.
Site Log established and background information entered
Site power voltages verified
Site environmental specifications verified
Required passwords, IP addresses, device names, and so on, available
Required tools available
Network connection equipment available
Cable-management brackets that are installed (optional, but recommended).
AC power cables that are connected to AC sources and router.
DC power cables that are connected to DC sources and router.
Network interface cables and devices connected
System power that is turned on.
System boot completes (STATUS LED is on).
Correct software configuration that is displayed after system banner appears
Creating a Site Log
The Site Log provides a record of all the actions related to installing and maintaining the router. Keep it in
an accessible place near the chassis so that anyone who performs tasks has access to it.
Cisco NCS 560-4 Router Hardware Installation Guide
34
Preparing for Installation
Installation Checklist