Cisco NCS 560-4

The chassis is shipped with mounting brackets that can be installed on the front of the chassis. To install the
brackets:
Mounting brackets are not required if the router is mounted on a 19-inch EIA rack.
Note
Procedure
Step 1 Remove the rack-mount brackets from the accessory kit and position them beside the router chassis.
Step 2 Position one of the brackets against the chassis side and align the screw holes.
Step 3 Secure the bracket to the chassis with the screws removed when performing Step 1. The recommended
maximum torque is 6.2 in.-lb (0.7 N-m).
The following figures shows how to attach the brackets on the Cisco NCS 560-4 Router for a ETSI rack and
a 23-inch EIA rack.
Figure 13: Installing the Mounting Brackets for n ETSI Rack
Cisco NCS 560-4 Router Hardware Installation Guide
40
Installing the Cisco NCS 560-4 Router
Installing the Router in a Rack