Cisco Nexus 9508 NX-OS User Manual

Step 4 Connect the Saf-D-Grid connector on the other end of the power cable to the Saf-D-Grid receptacle on the power supply.
Step 5 Turn on the circuit breaker for the DC power source circuit.
Step 6 Turn on the power supply by pressing its power switch to on.
Step 7 Verify that the OUT LED turns on and becomes green.
If you use both inputs, the IN LED is green. If you use only one input, the IN LED is blinking green.
Note
Installing or Replacing a 3-kW DC Power Supply
Before you begin
• The power source must be installed within reach of the power cables.
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
103
Replacing or Installing Modules, Fan Trays, and Power Supplies
Installing or Replacing a 3-kW DC Power Supply

Cisco Nexus 9508 NX-OS Specifications

General

Brand	Cisco
Model	Nexus 9508 NX-OS
Category	Switch
Language	English