CHAPTER 5
Managing the Switch
• Displaying Information About the Installed Hardware Modules, on page 49
• Displaying the Hardware Inventory for a Switch, on page 53
• Displaying the Backplane and Serial Number Information, on page 54
• Displaying Environmental Information for the Switch, on page 56
• Displaying the Current State of a Module, on page 57
• Displaying Temperatures for a Module, on page 59
• Connecting to a Module, on page 60
• Saving the Module Configuration, on page 61
• Shutting Down or Starting Up a Module, on page 62
• Purging a Nonfunctioning Module from the Running Configuration, on page 63
• Displaying Power Usage Information, on page 63
• Reload a Module, on page 64
• Rebooting a Switch, on page 65
• Overview of Supervisor Modules, on page 65
• Overview of Power Modes, on page 67
• Overview of Fan Trays, on page 72
Displaying Information About the Installed Hardware Modules
You can display information about the switch hardware and the hardware modules that are installed in the
switch chassis by using the show hardware command.
switch# show hardware
Cisco Nexus Operating System (NX-OS) Software
TAC support: http://www.cisco.com/tac
Documents: http://www.cisco.com/en/US/products/ps9372/tsd_products_support_seri
es_home.html
Copyright (c) 2002-2013, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained herein are owned by
other third parties and are used and distributed under license.
Some parts of this software are covered under the GNU Public
License. A copy of the license is available at
http://www.gnu.org/licenses/gpl.html.
Software
...
Hardware
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
49
To Next Page
Loading...
