EasyManuals Logo

Cisco Nexus 9508 NX-OS User Manual

Cisco Nexus 9508 NX-OS
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
CHAPTER 4
Connecting the Switch to the Network
Guidelines for Connecting Ports, on page 39
Connecting a Console to the Switch, on page 40
Connecting the Management Interface, on page 41
Creating the Initial Switch Configuration, on page 42
Connecting Interface Ports, on page 44
Guidelines for Connecting Ports
You can use C Form-factor Pluggable (CFP), Quad Small Form-Factor Pluggable (QSFP+, QSFP28, or
QSFP-DD), or Small Form-Factor Pluggable (SFP, SFP+ or SFP28) transceivers or RJ-45 connectors to
connect the ports on the line cards to other network devices.
For information about the transceivers currently being used with the switch, use the show inventory all
command.
Prevent damage to the fiber-optic cables that can separate from their cables. Keep the transceivers disconnected
from their fiber-optic cables when installing the transceiver in the line card. Before removing such a transceiver
from the switch, remove the cable from the transceiver.
To maximize the effectiveness and life of your transceivers and optical cables, do the following:
Wear an ESD-preventative wrist strap that is connected to an earth ground whenever handling transceivers.
The switch is typically grounded during installation and provides an ESD port to which you can connect
your wrist strap.
Do not remove and insert a transceiver more often than is necessary. Repeated removals and insertions
can shorten its useful life.
Keep the transceivers and fiber-optic cables clean and dust free to maintain high signal accuracy and to
prevent damage to the connectors. Contamination causes increased attenuation (loss of light), and should
be kept below 0.35 dB.
Clean these parts before installation to prevent dust from scratching the fiber-optic cable ends.
Clean the connectors regularly; the required frequency of cleaning depends upon the environment.
In addition, clean connectors if they are exposed to dust or accidentally touched. Both wet and dry
cleaning techniques can be effective; refer to your site's fiber-optic connection cleaning procedures.
Do not touch the ends of connectors. Touching the ends can leave fingerprints and cause other
contamination.
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
39

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Nexus 9508 NX-OS and is the answer not in the manual?

Cisco Nexus 9508 NX-OS Specifications

General IconGeneral
BrandCisco
ModelNexus 9508 NX-OS
CategorySwitch
LanguageEnglish

Related product manuals