Cisco Nexus 9508 NX-OS - Connecting to a Module

A threshold value of –127 indicates that no thresholds are configured or applicable.
Note
This command reports on only software-controlled modules, such as supervisors, system controllers,
line cards, fabric modules, fan trays, and power supplies. It reports on modules that are not controlled
by software, such as blank modules installed in empty slots to control airflow.
Note
Use the show environment temperature command to display the temperature readings for each of the
powered-up modules.
switch# show environment temperature
Temperature:
--------------------------------------------------------------------
Module Sensor MajorThresh MinorThres CurTemp Status
(Celsius) (Celsius) (Celsius)
--------------------------------------------------------------------
4 CPU 105 95 32 Ok
4 TD2-1 105 95 41 Ok
4 TD2-2 105 95 41 Ok
4 TD2-3 105 95 41 Ok
4 VRM-1 110 100 41 Ok
4 VRM-2 110 100 45 Ok
4 VRM-3 110 100 40 Ok
22 CPU 105 95 34 Ok
22 TD2-1 105 95 45 Ok
22 TD2-2 105 95 41 Ok
22 VRM-1 110 100 49 Ok
22 VRM-2 110 100 47 Ok
27 OUTLET 75 55 29 Ok
27 INLET 60 42 20 Ok
27 CPU 90 80 27 Ok
28 OUTLET 75 55 27 Ok
28 INLET 60 42 22 Ok
28 CPU 90 80 33 Ok
29 CPU 105 95 40 Ok
30 CPU 105 95 34 Ok
switch#
Connecting to a Module
You can connect to any module by using the attachmodule slot_number command. When the module prompt
appears, you can obtain further details about the module by using module-specific commands in EXEC mode.
You can also use the attach modulecommand to display the standby supervisor module information, although
you cannot configure the standby supervisor module using this command.
To see which slots are filled with modules, use the show inventory command.
Note
Use the attach module slot_number command to get direct access to a specific module.
This example shows how to attach to the supervisor in slot 28.
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
60
Managing the Switch
Connecting to a Module