Cisco Nexus 9508 NX-OS - Page 68

DescriptionLine Card State
This module is the active supervisor or system controller module and the switch is
ready to be configured.
active
The HA switchover mechanism is enabled on the standby supervisor module.HA-standby
The switchover mechanism is enabled on the standby system controller module.standby
Use the show module [slot_number] command to display information about all the installed modules or for
the module that you specify by its slot number.
This example shows how to display information about all the modules that are installed in a chassis.
switch# show module
Mod Ports Module-Type Model Status
--- ----- ----------------------------------- ------------------ ----------
4 36 36p 40G Ethernet Module N9k-X9636PQ ok
22 0 Fabric Module N9K-C9508-FM ok
24 0 Fabric Module N9K-C9508-FM powered-dn
26 0 Fabric Module N9K-C9508-FM powered-dn
27 0 Supervisor Module N9K-SUP-A active *
28 0 Supervisor Module N9K-SUP-A ha-standby
29 0 System Controller N9K-SC-A active
30 0 System Controller N9K-SC-A standby
Mod Power-Status Reason
--- ------------ ---------------------------
24 powered-dn Configured Power down
26 powered-dn Configured Power down
Mod Sw Hw
--- -------------- ------
4 6.1(4.11) 0.1010
22 6.1(4.11) 0.1010
27 6.1(4.11) 0.3011
28 6.1(4.11) 1.0
29 6.1(4.11) 0.2010
30 6.1(4.11) 0.2010
Mod MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
4 00-22-bd-f8-2a-83 to 00-22-bd-f8-2a-b6 SAL17257AHD
22 00-00-00-00-00-00 to 00-00-00-00-00-00 SAL17194HVX
24 00-00-00-00-00-00 to 00-00-00-00-00-00 SAL17194HRK
26 00-00-00-00-00-00 to 00-00-00-00-00-00 SAL17194HSR
27 00-22-bd-f6-9d-58 to 00-22-bd-f6-9d-69 SAL17184072
28 00-22-bd-fc-04-b0 to 00-22-bd-fc-04-c1 SAL1739DAUL
29 00-00-00-00-00-00 to 00-00-00-00-00-00 SAL17225YFS
30 00-00-00-00-00-00 to 00-00-00-00-00-00 SAL17225YG8
* this terminal session
switch#
This example shows how to display information about a module in a specific slot (slot 4) of the chassis.
Note
switch# show module 4
Mod Ports Module-Type Model Status
--- ----- ----------------------------------- ------------------ ----------
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
58
Managing the Switch
Displaying the Current State of a Module