Cisco ONS 15454 DWDM Manual

1-35
Cisco ONS 15454 DWDM Troubleshooting Guide, R7.0.1
78-17742-02
Chapter 1 General Troubleshooting
1.5 Restoring the Database and Default Settings
Figure 1-16 DCN Tools OSPF Dump
The dump, which provides the same information as a dump executed by special networking commands,
is available at the network view in the Maintenance > Diagnostic tab. You can select the access point
node in the Select Node drop-down list. To create the dump, click Retrieve. (To clear the dump, click
Clear.)
The contents of the dump file can be saved or printed and furnished to Cisco Technical Support for use
in OSPF network support.
1.5 Restoring the Database and Default Settings
This section contains troubleshooting for node operation errors that require restoration of software data
or the default node setup.
1.5.1 Restore the Node Database
Symptom One or more nodes do not function properly or have incorrect data.
Possible Cause Incorrect or corrupted node database.
Recommended Action Complete the procedures in the “Maintain the Node” chapter of the
Cisco ONS 15454 DWDM Procedure Guide.

Cisco ONS 15454 DWDM Specifications

General

Chassis Type	DWDM
Form Factor	Rack-mountable
Slots	17
Storage Temperature	-40 to 158°F (-40 to 70°C)
Relative Humidity	5% to 95% non-condensing
Power Supply	AC or DC
Cooling	Internal fans
Operating Temperature	23 to 104°F (-5 to 40°C)
Altitude	0 to 6500 ft (0 to 1981 m)
Safety Compliance	EN 60950-1
EMI Compliance	FCC Part 15