Cisco ONS 15454 DWDM - Provision Individual Card BBE or SES Thresholds in CTC

1-27
Cisco ONS 15454 DWDM Troubleshooting Guide, R7.0.1
78-17742-02
Chapter 1 General Troubleshooting
1.3.5 Performance Monitoring Counters and Threshold Crossing Alerts
Figure 1-11 Set Default BBE/SES Card Thresholds
Step 2
In the Defaults Selector field, click the transponder or muxponder card you wish to provision, then click
opticalthresholds > trunk > warning > 15min in the drop-down list.
Provision Individual Card BBE or SES Thresholds in CTC
Complete the following procedure to provision BBE or SES PM thresholds in CTC for an individual
TXP card.
Step 1 In node view (single-shelf mode) or shelf view (multishelf mode), double-click the applicable transponder
or muxponder card (TXP_MR_10G, TXPP_MR_2.5G, or MXP_2.5G_10G.)
Step 2 Click the Provisioning > OTN > G.709 Thresholds tabs (Figure 1-12).