Cisco Prisma II - Connecting Your Computer to the Chassis; To Connect a Computer to the Chassis

Connecting Your Computer to the Chassis
78-4015908-01 Rev F 81
Connecting Your Computer to the Chassis
Before you start LCI, you must first connect your computer to the chassis that
contains the module(s) you want to check.
Important:
 LCI only communicates with modules installed in the chassis to which your
computer is connected. To check other modules, you must connect your
computer to the chassis in which they are installed.
 If LCI does not communicate with a module in the chassis to which your
computer is connected, it may be necessary to update the LCI application.
To Connect a Computer to the Chassis
Complete the following steps to connect your computer to the chassis.
1 Plug one end of a 9-pin RS-232serial extension cable into your computer.
2 Plug the other end of the cable into the LCI port, labeled Local Craft Interface.
Standard Prisma II Chassis