Cisco Prisma II - To Disable the User Password Using ICIM

ICIM Password
78-4015908-01 Rev F 49
4 When Change Psw /Shift Off appears, press the
SHIFT
key to display Shift On,
and then enter the eight digits of your new password, using the 0-9 number keys.
If at any time you input a digit that is incorrect or wish to change a digit, use the
CAN (Cancel) function by pressing the
ALRM
key to delete that digit.
5 Press the
ENTER
key to input the new password.
Results:
 The ICIM updates the display to show if your password entry was accepted
or rejected.
 If the entry was accepted, you are able to return to the MAIN menu.
6 If the new password you entered is rejected, press the
SHIFT
key to return to the
password entry menu. Clear all digits using the CAN (Cancel) function, then re-
enter an 8-digit password using only the 0-9 number keys. Press the
ENTER
key to
input the password.
ICIM
ICIM
Shelf 7
Slot 15
ICIM
ICIM
Change Psw
87654321
Shelf 7
Slot 15
Shelf 7
Slot 15
TP014
Shelf 7
Slot 15
Change Psw
********
Change Psw
User Psw
Disable
Psw
Shift Off
Shift On
Shift On
Change Psw
SA Psw
To Disable the User Password using ICIM
If a user password has been entered, you may disable it at any time. However, the
current password must be active prior to disabling it. If the current password has
expired (more than 10 minutes have passed since your last keystroke), you must re-
enter the current password before disabling it.
1 Press the
ICIM
key.
2 Use the

key to scroll down until Password is highlighted.
3 Press the
SEL
key.
4 Use the

key to scroll down until Disable Psw is highlighted.
5 Press the
SEL
key to select Disable Psw.