Cisco Prisma II - Checking the Module Alarms Using LCI; To Check Alarms Using LCI

Checking the Module Alarms using LCI
78-4015908-01 Rev F 95
Checking the Module Alarms using LCI
Using LCI, you can check the alarm status of various parameters. Alarms that you
can check are listed below.
Alarms limits fall into one of the following categories.
 Major low
 Minor low
 Minor high
 Major high
To Check Alarms using LCI
Right-click the module, and then click Details.
Result: The Module Details window appears. The alarms are shown under
Parameters and Alarms.