Cisco Prisma II - Configuring the Module Using the ICIM; To Configure Parameters Using the ICIM

Configuring the Module using the ICIM
78-4015908-01 Rev F 57
Configuring the Module using the ICIM
To Configure Parameters using the ICIM
You can use the ICIM to configure the parameters of this module.
1 From the MAIN menu, press the

key to highlight the Shelf and Slot fields.
2 Press the
SEL
key to address the Shelf number. Then press the

key or the
key to scroll to the number of the desired shelf.
3 Press the
ENTER
key.
Result: The Slot field is highlighted.
4 Press the

key or the
keys to scroll to the number of the desired slot.
5 Press the
ENTER
key.
Result: The MODULE menu appears on the ICIM LCD.
6 To configure the module, press the
CFG
key.
7 Press the

key or the

key to scroll through the configurable controls
until you find the parameter of interest.
8 Press the
SEL
key to select the highlighted control.
9 Press the

key or the
key to activate or change the value of the selected
control.
10 Press the
ENTER
key to save the changes and return to the MAIN menu.