Starting LCI Software
When you start LCI, it polls the module(s) located in the chassis to which your
computer is attached. For each module it finds, LCI does the following:
Represents the module in the module tree of the main LCI window
Makes the polling information available so you can check and configure various
parameters
Important: Your computer must be connected to the chassis before you start LCI. For
instructions, refer to Connecting Your Computer to the Chassis (on page 81).
To Start LCI Software
Complete the following steps to start the LCI software.
1 Double-click the LCI icon on your Windows desktop.
Result: The LCI Detect Configuration window appears as shown below.
2 In the LCI Detect Configuration window, select the appropriate COM port,
chassis ID, and chassis type, and then click Start.
To Next Page
Loading...
