Cisco Prisma II - Operating the ICIM; Using the ICIM; To Access the ICIM LCD Contrast; ICIM MAIN Menu

Operating the ICIM
78-4015908-01 Rev F 51
Operating the ICIM
Using the ICIM
Once the module is installed, it runs without the aid of an operator. Unless alarms
are generated or your system configuration changes, you should not need to make
any adjustments to the module beyond the initial setup.
To Access the ICIM LCD Contrast
To access the ICIM LCD contrast control from the MAIN menu, press the
ICIM
key.
Use the

key to increase or the
key to decrease ICIM display contrast.
ICIM MAIN Menu
A few seconds after power-up, the MAIN menu appears. Press the
SEL
key to
select the specific option.
Display Description
Offline
Indicates TNCS or ROSA communication status with the ICIM2 or ICIM2-
XD.
Modules
Indicates the number of modules in the ICIM2 or ICIM2-XD domain.
Alarms
Displays the number of currently active alarms. Selecting this option
allows scrolling through all modules in alarm condition.
Scroll
Allows scrolling through all modules in the ICIM2 or ICIM2-XD domain.
Module
Shelf
Slot
Allows selection of any specific module in the ICIM2 or ICIM2-XD
domain.