Cisco Prisma II - Host Module; Host Module Features; Host Module Illustration

Chapter 1 Module Introduction
8 78-4015908-01 Rev F
Host Module
A host module is required to mount the application module in a standard Prisma II
Chassis. The host module doubles the density of the Prisma II Chassis by providing
two high density module slots for each current Prisma II slot. Its simple design
allows for efficient routing of RF and electrical signal between the chassis back plane
and each high density module.
Host Module Features
The host module has the following features:
 Provides upper and lower slots for two high density modules
 Incorporates a passive design for high reliability
 Provides for RF and DC routing between the chassis back plane and each high
density module
Host Module Illustration
Front View
Back View