Cisco Prisma II - To Change the User Password

Chapter 3 Operation using ICIM
48 78-4015908-01 Rev F
3 When User Psw/Shift Off appears, press the
SHIFT
key to display Shift On, and
then enter the eight digits of your password, using the 0-9 number keys.
 To change a digit you have just typed, use the CAN (Cancel) function by
pressing the
ALRM
key. This deletes the last digit typed.
4 Press the
ENTER
key to enter the password. The ICIM2 or ICIM2-XD display
updates to show whether your password entry was accepted.
 If the password is accepted, the word Accepted appears in the menu, and
you are able to return to the MAIN menu.
 If the password was rejected, the word Rejected appears in the menu.
Reasons for a password to be rejected include:
– Entering more than eight digits for the password.
– Pressing keys other than the 0-9 number keys.
– Entering an incorrect password if a valid password has been entered.
If the password is rejected, press the
SHIFT
key to return to the password
menu and re-enter the password as described in step 3 above.
ICIM
ICIM
Shelf 0
Slot 15
ICIM
ICIM
User Psw
12345678
Shelf 0
Slot 15
Shelf 0
Slot 15
TP013
Shelf 0
Slot 15
User Psw
1234****
User Psw
********
User Psw
Shift Off
Shift On
Rejected
Shift Off
Accepted
Shift Off
To Change the User Password
If a user password has been entered, it may be changed. However, the current
password must be active prior to changing it. If the current password has expired
(more than 10 minutes have passed since your last keystroke), you must re-enter the
current password before changing to a new one.
1 Access the Password menu as shown in the procedure To Access the Password
Menu (on page 46).
2 Use the

key to scroll down until Change Psw is highlighted.
3 Press the
SEL
key to select Change Psw.