Cisco Prisma II - Modifying Module Alarm Limits Using LCI; To Modify Alarm Limits Using LCI

Modifying Module Alarm Limits using LCI
78-4015908-01 Rev F 97
Modifying Module Alarm Limits using LCI
To Modify Alarm Limits using LCI
Using LCI, you can modify alarm limits for several parameters. Parameters whose
alarm limits you can change are listed below.
1 In the module tree, right-click the module, and then click Details.
Result: The Module Details window appears. The alarm limits are shown under
Parameters.
2 Double-click the limit you want to change.