Cisco SFE2000P User Manual

8-5
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-06
Chapter 8 Troubleshooting
Troubleshooting Overview
Warning SCE 2000 is fully operational
(as above) but one of the
following occurred:
• Line ports (GBE ports) to
the link are down
• Management port link is
down
• Temperature raised above
threshold
• Voltage not in required
range
• Fans problem
• Power supply problem
• Insufficient space on the
disk
Note Warning Note: If the
condition that caused the
SCE 2000 to be in
Warning state is resolved
(for example, link is up)
the SCE 2000 reverts to
Operational state.
Flashing orange
Warning Flashing orange
Failure System is in Failure state after
Boot due to one of the following
conditions:
• Power on test failure
• Three abnormal reboots in
less than 20 minutes
• Platform configured to enter
Failure mode consequent to
failure-induced reboot (this
is configurable using CLI
command)
Note Depending on the cause
of failure, the
management interface
and the platform
configuration may or
may not be
active/available. Red
Red
Table 8-2 SCE 2000 Operational States
SCE 2000 Operational Status Description Status LED State

Cisco SFE2000P Specifications

General

Brand	Cisco
Model	SFE2000P
Category	Network Router
Language	English