Cisco SFE2000P User Manual

CHAPTER
4-1
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-06
4
Installation and Maintenance
This chapter explains how to install a SCE 2000 platform in a rack or in a general tabletop or workbench
installation. Additionally, this chapter contains instructions for installing or replacing the power supply
units and fan modules.
Before you install, operate, or service the system, read the Regulatory Compliance and Safety
Information for the Cisco Service Control Engine . This guide contains important safety information you
should know before working with the system.
• Information About Preparing to Install the SCE 2000 Platform
• Installing the SCE 2000 Platform
• Removing and Replacing a Power Supply Unit
• How to Replace the Power Supply Unit
• Reconnecting the Power
• Fan Module Overview
• How to Replace the Battery
Information About Preparing to Install the SCE 2000 Platform
Before installing your SCE 2000 platform, you should consider the power and cabling requirements that
must be in place at your installation site, the equipment you need to install the platform, and the
environmental conditions your installation site must meet to maintain normal operation. This section
guides you through the process of preparing for your SCE 2000 platform installation and the installation
in a rack. The section contains the following topics:
• Tools and Parts Required
• Information About Site Requirement Guidelines

Cisco SFE2000P Specifications

General

Brand	Cisco
Model	SFE2000P
Category	Network Router
Language	English