Cisco SFE2000P User Manual

4-14
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-06
Chapter 4 Installation and Maintenance
Removing and Replacing a Power Supply Unit
Figure 4-13 Grounding the Unit (DC)
Removing and Replacing a Power Supply Unit
The procedures for removing and replacing the AC-input or DC-input power supply are explained in the
following sections:
Do not remove or install modules without using appropriate anti-static guard measures. The SCE 2000
includes an anti-static wrist strap in the accessory kit. Attach the copper tape strap to an unpainted metal
surface on the chassis. You may leave the strap connected to the chassis when your have finished.
Never install an AC power module and a DC power module in the same chassis.
• Information About the Power Supply
• Powering Down the Power Supply Unit and Disconnecting Input Power
• How to Remove the Power Supply Unit
Information About the Power Supply
The SCE 2000 is available in two power options:
• Dual line feed AC power — SCE 2000 is shipped with two appropriate AC power supply cords.
IN
PO
W
ER
B
OK
IN
PO
W
ER
A
OK
BYP
ASS 1
210422
21

Cisco SFE2000P Specifications

General

Brand	Cisco
Model	SFE2000P
Category	Network Router
Language	English