Cisco SFE2000P User Manual

8-8
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-06
Chapter 8 Troubleshooting
Troubleshooting Overview
Troubleshooting the Firmware Package Installation
Check the following to help isolate a problem in the installation of the firmware package.
Problems related to the installation of the firmware package could be any of the following:
• File not found in the expected location
• Wrong file type.
• Device to which the file is to be extracted is full.
Faulty power cable. Turn the switch to the off
position, remove the cable and
replace it.
Faulty power supply. If the system still fails to come
up when the power supply is
connected to a different power
source with a new power cable,
the power supply unit is
probably faulty. Contact a
service representative.
Table 8-4 Troubleshooting the Power Subsystem
Symptom Possible Cause Possible Solution
Table 8-5 Troubleshooting the Firmware Package Installation
Diagnostic Action
Enter the CLI command:
• configure
• Boot system <filename>
Symptom Possible Cause Possible Solution
Returned error is:
Error-File <filename>does
not exist
The package file does not exist in
the specified location.
Verify package file location and
try again.
In the output of the command,
the package file type is
management-image instead of
system-image
Package file type mismatch. Verify that you are trying to open
the correct package file.
In the output of the command,
the package file platform is not
the correct installation file for
the SCE 2000 .
Package file platform mismatch. Verify that you have the package
file appropriate to your platform
type.

Cisco SFE2000P Specifications

General

Brand	Cisco
Model	SFE2000P
Category	Network Router
Language	English