Cisco SFE2000P User Manual

5-11
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-06
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
Step 5: How to Configure the DNS Settings
The DNS configuration menu defines the IP address of the domain name server, which is used for DNS
lookup, as well as the default domain name, which is used to complete unqualified host names.
You may choose to skip the DNS configuration menu if you wish to accept all default values.
SUMMARY STEPS
1. Enter the DNS settings menu.
2. Enable or disable DNS lookup.
3. Type the default domain name to be used, and press Enter.
4. Type the IP address of the primary domain name server and press Enter.
5. You may configure up to three domain servers.
6. When IP addresses for all servers have been entered, exit the dialog by pressing Enter.
DETAILED STEPS
Step 1 Enter the DNS settings menu.
Would you like to enter the DNS configuration menu? [no]: y
Type yand press Enter.
The DNS settings dialog begins.
Step 2 Enable or disable DNS lookup.
• To enable DNS lookup, press Enter.
• To disable DNS lookup, type nand press Enter.
Enable IP DNS-based hostname translation? [yes]:
If you choose to disable DNS lookup, skip the rest of this section and go to . The rest of the dialog is not
presented, as it is irrelevant when DNS lookup is disabled.
Step 3 Type the default domain name to be used, and press Enter.
Note that there is no default domain name.
You may accept the default domain name or enter a new one.
Enter default domain name []:
Step 4 Type the IP address of the primary domain name server and press Enter.
Enter Primary DNS IP address:
Note that there is no default for this parameter.
Step 5 You may configure up to three domain servers.
Would you like to add another Name Server? [no]:
• To exit the DNS settings dialog, press Enter.
• To add another domain server, type yand press Enter.
You are asked to enter the IP address of the next domain name server.
Enter Secondary DNS IP address:
Step 6 When IP addresses for all servers have been entered, exit the dialog by pressing Enter.
Would you like to add another Name Server? [no]:

Cisco SFE2000P Specifications

General

Brand	Cisco
Model	SFE2000P
Category	Network Router
Language	English