Cisco SFE2000P User Manual

5-9
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-06
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
EXAMPLE:
Following is an example of changing all passwords. Password encryption is not enabled (default).
Enter a User password [cisco]: userinEnter an Admin password [cisco]: mng123Enter a Root
password [cisco]: cistechEnable passwords encryption? [no]:
Step 4: How to Configure Time Settings
The time settings menu configures all time and date related parameters in the system. The time settings
menu includes the following:
• Time zone
• Local time
• Date
• SNTP menu
You must enter the time setting menu in order to configure SNTP settings. You may choose to skip the
time settings menu if you wish to accept all default values.
Note Unlike all other settings defined in the system configuration, setting the time is done immediately and
not at the end of the setup process.
SUMMARY STEPS
1. Enter the time settings menu.
2. Type the time zone abbreviation and press Enter.
3. Type the minutes offset from UTC and press Enter.
4. If the time and date are correct, go to .
5. You are asked whether you wish to enter the SNTP configuration menu.
6. Configure the SNTP broadcast client. By default the SNTP broadcast client is not enabled.
7. Define the time interval between unicast updates.
8. You may enter an IP address for the SNTP unicast server. Type in the hostname or the IP address in
the form x.x.x.x, and press
9. Enter
DETAILED STEPS
Step 1 Enter the time settings menu.
Would you like to enter the Time settings menu? [no]: y
Type yand press Enter.
The time settings dialog begins.
Step 2 Type the time zone abbreviation and press Enter.
Enter time zone name [UTC]: CET
Step 3 Type the minutes offset from UTC and press Enter.
Enter time zone minutes offset from UTC: 60

Cisco SFE2000P Specifications

General

Brand	Cisco
Model	SFE2000P
Category	Network Router
Language	English