Cisco SFE2000P User Manual

8-10
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-06
Chapter 8 Troubleshooting
Troubleshooting Overview
Management link up:
• Mng LINK LED is
lit
• pingto management
interface fails
CLI commands
• show ip route
• show ip
default-gateway
One of the following
configurations may be
wrong:
• IP address / subnet
mask
• IP default gateway
See Connecting the
Management Interfaces
and Performing Initial
System Configuration
Refer to " IP
Configuration " in the
Cisco Service Control
Engine (SCE) Software
Configuration Guide.
CLI command
show access-lists
An ACL may be
assigned that denies
entry.
See Connecting the
Management Interfaces
and Performing Initial
System Configuration
Refer to " Access
Control Lists " in the
Cisco Service Control
Engine (SCE) Software
Configuration Guide
• Telnet connection
cannot be
established
• Mng LINK LED is
not lit (link is
down)
• CLI command
show interface
mng
Management interface
IP address or subnet
mask is incorrect.
Check / reconfigure
management port IP
address and subnet
mask
• Telnet connection
cannot be
established
• Mng LINK LED is
lit (link is up)
CLI command: show
telnet status
Telnet server is
disabled.
Enable Telnet server:
service telnetd
CLI command: show
telnet sessions
Too ma ny Te lnet
connections (up to 5
concurrent sessions are
supported).
Close one or more of the
open Telnet sessions.
CLI command:
show ip
default-gateway
Default gateway is
incorrect (when the host
used as client is not in
the same network as the
SCE Platform).
Check / reconfigure
default gateway. See
Connecting the
Management Interfaces
and Performing Initial
System Configuration
Refer to " IP
Configuration " in the
Cisco Service Control
Engine (SCE) Software
Configuration Guide.
Table 8-6 Troubleshooting the Management Subsystem (continued)
Symptom Diagnostic Action Possible Cause Possible Solution

Cisco SFE2000P Specifications

General

Brand	Cisco
Model	SFE2000P
Category	Network Router
Language	English