Cisco SFE2000P User Manual

5-5
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-06
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
Access Control List number How many ACLs will be necessary? What IP
addresses will be permitted/denied access for each
management interface? You may want ACLs for
the following:
• Any IP access
• Telnet access
• SNMP GET access
• SNMP SET access
list entries (maximum 20 per list) IP address, and whether permitted or denied
access.
IP access ACL ID number of the ACL controlling IP access.
telnet ACL ID number of the ACL controlling telnet access.
SNMP Configuration
SNMP agent status Enable or disable SNMP management.
GET community names Community strings to allow GET access and
associated ACLs (maximum 20).
SET community names Community strings to allow SET access and
associated ACLs (maximum 20).
trap managers (maximum 20) Trap manager IP address, community string, and
SNMP version.
Authentication Failure trap status Sets the status of the Authentication Failure traps.
enterprise traps status Sets the status of the enterprise traps.
system administrator Name of the system administrator.
Topology Configuration
Connection mode Is the SCE 2000 installed using inline topology or
receive-only topology using an optical splitter?
type of deployment Is this a cascade topology, with two SCE 2000 s
connected via the cascade ports? Or is this a single
platform topology?
physically connected link (cascade topology only) In a cascade deployment this parameter sets the
index for the link that this SCE 2000 is deployed
on. The options for SCE 2000 are link-0 or link-1.
In a single- SCE 2000 Platform deployment this
parameter is not relevant since one SCE 2000 is
deployed on both links. In this case the link
connected to port1-port2 is by default link-0 and
the link connected to port3-port4 is be default
link-1.
priority (cascade topology only) If this is a cascaded topology, is this SCE 2000 the
primary or secondary SCE 2000 ?
Table 5-1 Setup Command Parameters
Parameter Definition

Cisco SFE2000P Specifications

General

Brand	Cisco
Model	SFE2000P
Category	Network Router
Language	English