Cisco SG350X-24 User Manual

Administration: Stack Management
Stack Ports
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 128
7
• When attempting to connect a unit to a stack whose topology is not a ring/chain (for
example, trying to connect a unit to more than two neighboring units - star topology),
only two stack LAGs can be active, the remainder of the stack ports are set to standby
mode (inactive).
Default Stack and Network Ports
All ports are configured as network ports by default.
Auto Selection of Port Speed
The stacking cable type is discovered automatically when the cable is connected to the port
(auto-discovery is the default setting). The system automatically identifies the stack cable type
and selects the highest speed supported by the cable and the port.
A SYSLOG message (informational level) is displayed when the cable type is not recognized.

Cisco SG350X-24 Specifications

General

Model	SG350X-24
Layer	Layer 3
Power Supply	Internal
Rack Mountable	Yes
RAM	512 MB
Flash Memory	256 MB
MAC Address Table	16K entries
Power over Ethernet (PoE)	No
Uplink Ports	4 x 10 Gigabit Ethernet
Jumbo Frame Support	Yes
Power Dedicated to PoE	Not applicable
Dimensions	440 x 44 x 350 mm
Stacking	Yes
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Relative Humidity	10% to 90% (non-condensing)
Power Consumption	30W (maximum)