Security
Storm Control
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 312
16
• HTTPS Service—Indicates whether the HTTPS service is enabled or disabled.
• SNMP Service—Indicates whether the SNMP service is enabled or disabled.
• Telnet Service—Indicates whether the Telnet service is enabled or disabled.
• SSH Service—Indicates whether the SSH server service is enabled or disabled.
STEP 3 Click Apply. The services are written to the Running Configuration file.
The TCP Service Table displays the following fields for each service:
• Service Name—Access method through which the device is offering the TCP service.
• Type—IP protocol the service uses.
• Local IP Address—Local IP address through which the device is offering the service.
• Local Port—Local TCP port through which the device is offering the service.
• Remote IP Address—IP address of the remote device that is requesting the service.
• Remote Port—TCP port of the remote device that is requesting the service.
• State—Status of the service.
The UDP Service table displays the following information:
• Service Name—Access method through which the device is offering the UDP service.
• Type—IP protocol the service uses.
• Local IP Address—Local IP address through which the device is offering the service.
• Local Port—Local UDP port through which the device is offering the service.
• Application Instance—The service instance of the UDP service. (For example, when
two senders send data to the same destination.)
Storm Control
This section describes storm control. It covers the following topics:
• Storm Control
• Storm Control Statistics
To Next Page
Loading...
Need help?
General
