Cisco SG350X-24 User Manual

26
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 571
Access Control
The Access Control List (ACL) feature is part of the security mechanism. ACL definitions
serve as one of the mechanisms to define traffic flows that are given a specific Quality of
Service (QoS). For more information see Quality of Service.
ACLs enable network managers to define patterns (filter and actions) for ingress traffic.
Packets, entering the device on a port or LAG with an active ACL, are either admitted or
denied entry.
This section contains the following topics:
•Overview
• MAC-Based ACLs Creation
• IPv4-based ACL Creation
• IPv6-Based ACL Creation
• ACL Binding
Overview
An Access Control List (ACL) is an ordered list of classification filters and actions. Each
single classification rule, together with its action, is called an Access Control Element (ACE).
Each ACE is made up of filters that distinguish traffic groups and associated actions. A single
ACL may contain one or more ACEs, which are matched against the contents of incoming
frames. Either a DENY or PERMIT action is applied to frames whose contents match the
filter.
The various devices supports the following number of ACLs and ACEs:
Device Max ACLs Max ACEs
SG550XG 2K 2K

Cisco SG350X-24 Specifications

General

Model	SG350X-24
Layer	Layer 3
Power Supply	Internal
Rack Mountable	Yes
RAM	512 MB
Flash Memory	256 MB
MAC Address Table	16K entries
Power over Ethernet (PoE)	No
Uplink Ports	4 x 10 Gigabit Ethernet
Jumbo Frame Support	Yes
Power Dedicated to PoE	Not applicable
Dimensions	440 x 44 x 350 mm
Stacking	Yes
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Relative Humidity	10% to 90% (non-condensing)
Power Consumption	30W (maximum)