Cisco SG350X-24 User Manual

VLAN Management
Regular VLANs
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 208
11
Regular VLANs
This section describes the GUI pages used to configure various types of VLANs. This section
describes the following processes:
• Regular VLAN Overview
• Interface Settings
• Port to VLAN
• Port VLAN Membership
• GVRP Settings
• MAC-based VLAN Group Overview
• Subnet-based VLAN Groups Overview
• Protocol-based VLAN Groups Overview
Regular VLAN Overview
VLAN Configuration Workflow
To configure VLANs:
1. Create the required VLANs as described in the VLAN Settings section.
2. Set the desired VLAN-related configuration for ports and enable QinQ on an interface as
described in the Interface Settings section.
3. Assign interfaces to VLANs as described in the Port to VLAN section or the Port VLAN
Membership section.
4. View the current VLAN port membership for all the interfaces as described in the Port
VLAN Membership section.
5. If required, configure VLAN groups as described in the MAC-based VLAN Group
Overview and Subnet-based VLAN Groups Overview sections.
6. If required, configure TV VLAN as described in the Access Port Multicast TV VLAN and
Customer Port Multicast TV VLAN sections.

Cisco SG350X-24 Specifications

General

Model	SG350X-24
Layer	Layer 3
Power Supply	Internal
Rack Mountable	Yes
RAM	512 MB
Flash Memory	256 MB
MAC Address Table	16K entries
Power over Ethernet (PoE)	No
Uplink Ports	4 x 10 Gigabit Ethernet
Jumbo Frame Support	Yes
Power Dedicated to PoE	Not applicable
Dimensions	440 x 44 x 350 mm
Stacking	Yes
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Relative Humidity	10% to 90% (non-condensing)
Power Consumption	30W (maximum)