Name: Cisco SG350X-24
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Security: SSH Client

Change User Password on the SSH Server

345 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x

Change User Password on the SSH Server

To change the password on the SSH server:

STEP 1 Click Security > SSH Client > Change User Password on SSH Server.

STEP 2 Enter the following fields:

• Server Definition—Define the SSH server by selecting either By IP Address or By

Name. Enter the server name or IP address of the server in the Server IP Address/

Name field.

• IP Version—If you selected to specify the SSH server by IP address, select whether that

IP address is an IPv4 or IPv6 address.

• IPv6 Address Type—If the SSH server IP address is an IPv6 address, select the IPv6

address type. The options are:

- Link Local—The IPv6 address uniquely identifies hosts on a single network link. A

link local address has a prefix of FE80, is not routable, and can be used for

communication only on the local network. Only one link local address is supported.

If a link local address exists on the interface, this entry replaces the address in the

configuration.

- Global—The IPv6 address is a global Unicast IPV6 type that is visible and

reachable from other networks.

• Link Local Interface—Select the link local interface from the list of interfaces.

• Server IP Address/Name—Enter either the IP address of the SSH server or its name,

depending on what was selected in Server Definition.

• Username—This must match the username on the server.

• Old Password—This must match the password on the server.

• New Password—Enter the new password and confirm it in the Confirm Password

field.

STEP 3 Click Apply. The password on the SSH server is modified.

Questions and Answers:

Need help?

Do you have a question about the Cisco SG350X-24 and is the answer not in the manual?

Cisco SG350X-24 Specifications

General