Cisco SG350X-24 User Manual

Administration: Stack Management
Stack Management
133 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
7
Stack Management
To configure the stack:
STEP 1 Click Administration > Stack Management.
The operational status of a standalone device or a stack is displayed in the Global Stack
Parameters block.
• Stack Mode—Displays one of the following options:
- Native Stacking—Device is part of a stack in which all of the units are of the same
type.
- Hybrid Stacking—Device is part of a stack that can consist of either mixed types of
350 devices or mixed types of 550 devices (but not a mix of 350 and 550 devices).
• Stack Topology—Displays whether the topology of the stack is chain or ring.
• Stack Master—Displays the unit ID of the master unit of the stack.
Stack Topology View
This view provides a graphical view of the device. Hovering over it displays the unit number,
its function in the stack (master, backup or slave) and the devices that it is connected to in the
stack and through which stacking ports. An example is shown below:

Cisco SG350X-24 Specifications

General

Model	SG350X-24
Layer	Layer 3
Power Supply	Internal
Rack Mountable	Yes
RAM	512 MB
Flash Memory	256 MB
MAC Address Table	16K entries
Power over Ethernet (PoE)	No
Uplink Ports	4 x 10 Gigabit Ethernet
Jumbo Frame Support	Yes
Power Dedicated to PoE	Not applicable
Dimensions	440 x 44 x 350 mm
Stacking	Yes
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Relative Humidity	10% to 90% (non-condensing)
Power Consumption	30W (maximum)